Industry

Ten points to maintain electric pallet jack suppliers!

0

Published by NEWTON May 28,2020

As a powerful assistant in the warehousing and logistics industry, electric pallet truck manufacturers improve work efficiency, ensure the safety of operators and make work easier. How to maintain an electric pallet jack suppliers? The following NEW NEWTON will give you a detailed introduction.

1. The electric pallet truck manufacturers battery is strictly prohibited from overcharging or over-discharging.

2. When charging the electric pallet jack suppliers, pay attention to keep the charging environment clean and ventilated. The charging equipment must be isolated from the battery. Fireworks are strictly prohibited.

pallet jack suppliers

3. Place the electric pallet truck manufacturers battery in a clean, dry, well ventilated area, do not expose it to direct sunlight, or turn the battery upside down, and do not hit or pressurize the battery.

4. After using the electric pallet jack suppliers, you need to clean the dirt and garbage on the car and check if the power cord is intact and not damaged.

5. Check if the electric pallet truck manufacturers cylinder is leaking, joints, hoses, etc., and if the insulation part of the appliance is normal.

6. Always pay attention to check the wear of the load-bearing wheel, balance wheel and drive wheel of the electric pallet jack suppliers, and replace it in time;

7. When getting out of the electric pallet truck manufacturers, check the surrounding area for obstacles. Do not let the electric pallet jack suppliers collide with obstacles. If an accident occurs and the vehicle is out of control, pull off the power switch and cut off the power.

8. Test whether the electromagnetic brake is easy to use when driving the electric pallet truck manufacturers;

pallet jack suppliers

9. When the electric pallet jack suppliers cannot be started, turn off the forward and reverse switches and turn it on again to start.

10. Before leaving the electric pallet truck manufacturers, the operator should pull up the handbrake to pull up the main power supply, remove the key and then leave the electric pallet jack suppliers.

The above is the basic maintenance and maintenance knowledge of the electric pallet truck manufacturers. Only the daily insistence can see the effect of maintenance.

< >
Latest posts