Industry

What are the maintenance of the small hydraulic platform lift?

0

Published by NEWTON May 28,2020

With the increasing use of small hydraulic platform lift, the maintenance that comes with them should also attract people's attention. The following NEW NEWTON will come to detail.

When the small hydraulic platform lift is being serviced, the personnel enter the interior of the small hydraulic platform lift, and the elevator must be suspended to prevent the sudden drop of the small hydraulic platform lift and cause casualties. First check the lubrication and wear of the small hydraulic platform lift rollers, intermediate shafts and bearings. Secondly, check the hydraulic oil quality and oil level of the small hydraulic platform lift. When the small hydraulic platform lift is raised to the highest, the hydraulic oil surface should be 40-50mm higher than the bottom of the fuel tank. When the hydraulic oil color becomes dark, the oil is sticky or there is any foreign matter such as gravel in the oil, the hydraulic oil should be replaced in time. This is the small hydraulic platform lift that is routinely maintained.

small hydraulic platform lift

For the half-year maintenance of the small hydraulic platform lift, the first step is to check the hydraulic piping and joints of the small hydraulic platform lift. The oil pipe must not be damaged and the street should not be loose. The second step is to disassemble the oil return throttle valve, blow the plunger with compressed air, wash it with oil and reinstall it.

Finally, the year-end maintenance of the small hydraulic platform lift. Check the hydraulic and pipe connection parts of the small hydraulic platform lift. If the pipe is damaged, replace it immediately; tighten the oil pipe joint when the connection is loose. The second is to remove and disassemble the lowering valve, and use the compressed air to blow the valve core and reinstall it. Finally, all the hydraulic oil in the small hydraulic platform lift fuel tank is used up to open the fuel tank, take out the suction filter and wash it, put it back into the fuel tank, install it in place, and refill the fuel tank with new hydraulic oil.

< >
Latest posts