Four major failures of all-electric trucks!

As a new type of electric logistics handling equipment, pallet truck manufacturers have already occupied a place in the vast market. Some problems will occur in the operation of pallet truck suppliers. How should we solve them?

1. When the pallet truck manufacturers is greatly increased, it causes jitter.

1. Significantly increase the gas in the pallet truck manufacturers cylinder, which can be solved by using the load multiple times and lifting method.

2. Pallet truck suppliers hydraulic system seepage, repair and replacement of oil seals and hydraulic cylinders.

Second, the pallet truck suppliers is self-sliding when there is load

1. The pallet truck manufacturers oil pipe or oil pipe joint has oil leakage, and the seal can be replaced.

2. Electromagnetic, manual reversing valve, check valve has waste stuck or the seal ring is worn out, causing internal leakage. Solution: Clean the valve block to replace the seal.

Third, the pallet truck manufacturers is slow to lift or can not start

1. There is less fuel in the pallet truck suppliers fuel tank, you must add hydraulic oil or replace it all.

2. The pallet truck manufacturers working pressure of the relief valve is not enough to adjust again.

3. The pallet truck suppliers oil pump is excessively worn, causing internal leakage and needs to be replaced.

4. Electromagnetic, manual reversing valve, check valve, safety valve wear or seal wear and aging, need to be replaced.

5. The pallet truck manufacturers hydraulic oil temperature is too long, the hydraulic oil is degraded, the viscosity is degraded, and the leakage is caused, and the hydraulic oil is removed.

Fourth, the driving wheel causes abnormal noise when pallet truck suppliers driving.

1. Mix hard dirt in the pallet truck manufacturers lubricating oil and update the lubricating oil

2. The pallet truck suppliers bearing is excessively worn or destroyed and needs to be replaced.