Principles and steps for installing small electric forklift parts in electric

The application of small electric forklift is gradually popularized in the shelf rooms of workshops and warehouses. After we purchased the small electric forklift from electric forklift manufacturers china, because of the consideration of transportation space and safety, it is often not a finished product, and some parts need to be installed by yourself. Then, the installation problem of small electric forklift has become a very important issue. Next, follow us to understand the principles and steps of installing small electric forklift components.

The installation of small electric forklift usually follows the installation principle from bottom to top, from inside to outside, from back to front, and from left to right. Let's take a look at the specific steps:

1. The piston ring should be used as a complete set, and can not be disassembled and assembled at will. Start installation from the third ring.

2. Do not touch the piston, the surface of the crankshaft, the connecting rod, the piston, the crankshaft, the camshaft at will. When installing these parts, the oil must be evenly coated for the purpose of protection and lubrication.

3. Apply butter to the O-ring as required, and then install the cylinder liner. Electric forklift manufacturers china reminds everyone not to knock the cylinder liner during installation.

4. Remember not to install the ring in the vertical or horizontal direction of the small electric forklift. When installing the ring opening, it is appropriate to stagger at least 120°.

5. Electric forklift manufacturers china has another thing to tell you that the cylinder head gasket can be installed after the oil is applied, and the process is irreversible.

6. When installing the cylinder head screws, electric forklift manufacturers china should also remind everyone to pay attention. The wrench should be tightened from the middle to the four sides of the cylinder head screw in 2-3 times to ensure that each screw is evenly stressed, and then from the middle to the center. Tighten the connecting rod of the crankshaft bush in 2-3 times at both ends.

7. Install the piston connecting rod in the original direction of the piston as required, and use special tools to install the piston connecting rod. The piston cannot be knocked as well, and the oil must be evenly applied to the connecting rod bush.

8. Pay attention to the alignment of the gears when installing the high-pressure fuel injection pump gears and camshafts. Electric forklift manufacturers china believes this is very important.

The above are the principles and steps for installing small electric forklift parts in electric forklift manufacturers china. I hope our content can be helpful to everyone.