Is there any remedy for the battery cover of the electric forklift components?

Electric forklift components battery during use, more or less due to improper use of the shell rupture, electric lift truck parts battery casing damage has natural aging factors, but also human factors. If the battery is replaced because the battery case of the electric forklift components is broken, the cost is too high. I teach you some simple electric lift truck parts battery case remedy:

Electric forklift components battery casing mainly adopts plastic welding method. The specific operation steps are as follows:

1. First find the approximate range of the rupture of the battery casing of the electric lift truck parts.

2. Tighten the electric forklift components and liquid cover, brush the surface of the electric lift truck parts battery cover with a brush, and dry the surface of the battery cover of the electric forklift components with a welding torch. Seal the ventilation hole with a transparent tape or label paper. it is good. It is best to prepare a set of electric lift truck parts and liquid cover. The vent hole of the electric forklift components is sealed with a plastic rod heated by a welding torch, which is more convenient for maintenance.

3. The side of the battery compartment of the electric lift truck parts is facing up, and the water around the rupture of the battery compartment of the electric forklift components is cleaned with a brush and water, and then the moisture of the battery casing of the electric lift truck parts is blown by a welding torch.

4. Select the gear position of the welding torch, heat the plastic rod to make it melt and evenly apply it around the rupture of the battery cover of the electric forklift components. The shell of the scrap battery or the recorder casing prepared in advance will not be restricted. The electric lift truck parts battery case is broken and continues to heat for one or two minutes. After it is completely bonded, stop heating and cool down.

5. unscrew the electric forklift components and add liquid cover, remove the transparent tape on the electric lift truck parts and liquid cover to check the liquid level. If there is leakage and lack of liquid, add electrolyte. If it is not urgent after repair, it should supplement the charging and density adjustment of the electric forklift components battery; if it is urgent, it can be directly loaded. Finally, if the electric lift truck parts battery case cannot be repaired, only replace the electric forklift components battery and solder it in sequence.

If your electric lift truck parts battery case is broken, try the above method, which is very cost effective!