Step for warehouse forklift manufacturer to install electric forklift accessorie

In the work of warehouse workshops, the application of electric forklifts has gradually spread. When the bosses bought the electric forklift from the warehouse forklift manufacturer, due to transportation space and safety considerations, it is often not a finished product, and some forklift accessories need to be installed by themselves. Then, the installation of the electric forklift becomes a very important issue. Next, follow us to understand the principles and steps of installing electric forklift accessorie.

The installation of electric forklifts usually follows the installation principle from bottom to top, from inside to outside, from back to front, and from left to right. Let's take a look at the specific steps:

1. The piston ring should be used in its entirety. It cannot be disassembled and assembled arbitrarily, and installation starts from the third ring.

2. Do not touch the piston, the surface of the crankshaft pad, the connecting rod, the piston, the crankshaft, the camshaft at will. Install these parts to apply oil evenly, for the purpose of protection and lubrication.

3. Apply butter to the O-ring as required, and then install the cylinder liner. Warehouse forklift manufacturers remind everyone not to hit the cylinder liner during the installation process.

4. Remember not to install the ring in the vertical or horizontal direction. When installing the opening of the ring, it is necessary to stagger at least 120 °.

5. One more thing for warehouse forklift manufacturers to tell you is that you can only install the cylinder pad after applying oil, the process is irreversible.

6. When installing the cylinder head reeling, the warehouse forklift manufacturers should also remind everyone to pay attention to the wrench from the middle to the periphery, tighten the cylinder head screws 2-3 times to ensure that each reel is evenly stressed, and then from the middle to two End-tighten the crankshaft shoe connecting rods 2-3 times.

7. Install the piston connecting rod in the original direction of the piston according to the requirements. Use special tools to install the piston connecting rod. It is also impossible to strike the piston, and the engine oil is evenly spread on the connecting rod pad.

8. Pay attention to the alignment of the gears when installing the gears and camshafts of high-pressure fuel injection pumps. The warehouse forklift manufacturers consider this to be very important.

The above are the principles and steps for warehouse forklift manufacturers to install electric forklift accessories. I hope our content can be helpful to everyone. If you have any other questions about electric forklifts, please call us and we will provide you with warm service.