How to charge a semi electric stacker suppliers battery?

The electric stacker manufacturers is an artificial push-pull walk that electrically lifts and lowers. The semi electric stacker suppliers is suitable for short-distance transportation in factories, warehouses, logistics and other enterprises, and for loading and unloading in areas where workload is small. The maintenance of the electric stacker manufacturers is relatively simple. The maintenance of the battery in the key components is the most important. How to charge the battery of the semi electric stacker suppliers? We understand from the following points.

1. The charging environment of the electric stacker manufacturers is mainly clean and ventilated. When conditions permit, the battery can be taken out or the cover of the semi electric stacker suppliers can be opened;

2. The electrolyte level of the electric stacker manufacturers should be 15mm higher than the partition. Below this scale line, the electrolyte should be added in time to prevent the battery from losing electricity and affect the battery life of the semi electric stacker suppliers. The temperature of the electrolyte shall not exceed 45 degrees during charging;

3. It is not possible to expose the open flame when charging the electric stacker manufacturers. Because the battery will generate a lot of flammable gas during the charging process, the semi electric stacker suppliers will prevent fire during charging.

4. Electric stacker manufacturers should avoid skin and acid contact during charging. If there is contact, use plenty of soapy water or consult a doctor.

5. The battery should be kept clean and dry in peacetime. It is not allowed to put other objects on the battery of the semi electric stacker suppliers;

6. The used batteries of the electric stacker manufacturers should be disposed of in accordance with the national environmental protection law.

The semi electric stacker suppliers can generally carry 2 tons of load, and the load weight is reduced with the load curve after more than 2 meters. After raising 2 meters, the load is 1-1.3 tons, and the increase to 3 meters can only load 800 kilograms. This is related to the load curve. The higher the height, the lower the load. A electric stacker manufacturers will have a “loss of load” when it is more than 2 meters.

The semi electric stacker suppliers has a load curve change diagram produced by the manufacturer, and the stack should be strictly in accordance with this graph. Don't be lucky: maybe, probably, maybe not! If it happens, then this damage will be fatal. Therefore, the purchase of electric stacker manufacturers must be based on the actual use of the situation! Then is to choose products that meet the safety standards, reliable after-sales business.